LINK Systems OmniLink - PLC Interface - Manual (Page 45)

June 5, 2000 Man ual Rev 1 .0
5.18
Value:
Standard Numeric
Meaning:
0 = All Conditions OK
1 = Communication Failure
2 = Bypassed
3 = Error Condition Exists - See Channel Status
4 = Option is Not Installed
Section 5.7.56 Parameter 056 - Auto-Setup Module Enabled Flag
Value:
Standard Numeric
Meaning:
0 = Auto-Setup NOT enabled
1 = Auto-Setup enabled
Section 5.7.57 Parameter 057 - Auto-Setup Slide Adjust Switch Flag
Value:
Standard Numeric
Meaning:
The slide adjust switch position as reported by the auto-setup module.
0 = Slide adjust switch OFF
1 = Slide adjust switch ON
Section 5.7.58 Parameter 058 - Auto-Setup Module Status Code
Value:
Standard Numeric
Meaning:
0 = All Conditions OK
Non-Zero = Error Condition Exists