LINK Systems OmniLink - PLC Interface - Manual (Page 41)

June 5, 2000 Man ual Rev 1 .0
5.14
Standard Numeric, 1 decimal place
Meaning:
Same as parameter 35
Section 5.7.37 Parameter 037 - Peak Forward Tonnage (Channel 3)
Value:
Standard Numeric, 1 decimal place
Meaning:
Same as parameter 35
Section 5.7.38 Parameter 038 - Peak Forward Tonnage (Channel 4)
Value:
Standard Numeric, 1 decimal place
Meaning:
Same as parameter 35
Section 5.7.39 Parameter 039 - Peak Forward Tonnage (Total)
Value:
Standard Numeric, 1 decimal place
Meaning:
Same as parameter 35
Section 5.7.40 Parameter 040 - Peak Reverse Tonnage (Channel 1)
Value:
Standard Numeric, 1 decimal place
Meaning:
The peak reverse tonnage registered on this channel for the last hit. This value is in .1 tons. If “Send
Decimal Point” is “No” then the PLC must assume a decimal place of 1. For example: