LINK Systems OmniLink - PLC Interface - Manual (Page 38)

June 5, 2000 Man ual Rev 1 .0
5.11
Section 5.7.19 Parameter 19 - Press Stroking Mode
Value:
Standard Numeric
Meaning:
Numeric code for the stroking mode of the press. The following codes apply:
1 = Inch
2 = Single Stroke
3 = Auto Single Stroke
4 = Continuous
5 = Timed Inch
6 = Setup/Stop Time Test
7 = Continuous on Demand
8 = Maintained Continuous
Section 5.7.20 Parameter 020 - Mode Select Key Flag
Value:
Standard Numeric
Meaning:
Non-Zero if Mode Select Key is active. The PLC can use this flag to give itself a mode select
capability without having to have a separate keyswitch.
Section 5.7.21 Parameter 021 - Motor Running Flag
Value:
Standard Numeric
Meaning:
Non-Zero if Motor is running.
Section 5.7.22 Parameter 022 - Clutch/Brake Flag