Hanna Instruments HI 2214 - Manual (Page 22)

22
LOT LOGGING (HI 2215 only)
Select “ StAb” (for stability logging) or the desired time interval.
To start interval logging press LOG key while the instrument is in
measurement mode.
When the selected interval is reached, the instrument will display the
current lot number on the primary LCD line, the record number on the
secondary LCD line and the “
LOG“ tag (see example below: Lot 5 record 7)
followed by the number of free records on the corresponding memory space.
If stability logging is selected, a complete set of data is memorized every
time the reading becomes stable after an unstable condition.
To stop interval logging press
LOG key again.
Note: When pressing any key that is not active, while Log interval is
running, the following message is displayed for a few seconds:
VIEW LOGGED DATA
Press RCL while in measurement mode to retrive the stored information.
If no data was logged for the selected measurement range and no lots
are memorized (
HI 2215 only), one of the next messages will be
displayed:
No records:
No pH measurement records:
No Relative mV and mV records: