FeiYu Tech FY-41AP - Manual (Page 30)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
- 30 -
Via remote control and OSD overlay menu set FY-41AP
Attention: Please be cautious when you into the OSD overlay menu to adjust the
FY-41AP parameters. We strongly suggest you do not install propeller to do the
(1) You can not execute Combination Stick Commands (CSC) to start the motor
when you in the OSD overlay menu. If you want to start the motor please exit the
OSD setting menu.
(2) You can not enter the OSD setting menu after you execute Combination Stick
Commands (CSC) to start the motor. If you want to enter the OSD setting menu
please wait the FY-41AP into the state before execute Combination Stick
Commands (CSC).
(1) Activate the OSD setup menu: switch " Hovering Mode " to the
Launch Mode(RTH)" 6 times in SW1, between two switching it has to be less than 3
seconds, the process is as follows: Hovering Mod→Auto Return To Launch Mode(RTH)
→Hovering Mod →Auto Return To Launch Mode(RTH) →Hovering Mod →Auto Return To
Launch Mode(RTH) →Hovering Mod →Auto Return To Launch Mode(RTH) →Hovering
Mod →Auto Return To Launch Mode(RTH) →Hovering Mod→Auto Return To Launch
Mode(RTH). This will activate OSD setup menu interface.
(2) Move Elevator stick to the project you want to set.
(3) Move aileron stick to the project you want to set.
(4) Please put elevator stick to SAVE, after your setting.Through the stick of ailerons
carried out to save the action, when saving, "SAVE" will flicker for two seconds, the end of
the flashing, been saved successful.