FeiYu Tech FY-41AP - Manual (Page 22)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
- 22 -
Start Motor and check the Motor rotation direction
Start Motor : When using multi-rotor firmware, pushing throttle stick before takeoff will
not start the motors. You have to execute Combination Stick Commands (CSC) in
stabilized mode or Hovering mode (Can not in Auto Return To Launch Mode(RTH) ) in
order to start motors. (Please do not install propeller yet.)
Meet the following conditions:
 Put Throttle stick to the lowest position
 Put Aileron stick to any endpoint position
 Put Elevator stick to any endpoint position
 Put Rudder stick to any endpoint position
Please slowly push the throttle and according to the picture ―Motor Mixer‖ shows to
check the motor rotation direction is right or not.
Attention:
(1) Altitude Stabilized Mode and Hovering Mode both can execute Combination Stick Commands
(CSC) to start the motor.
(2) In Hovering mode, if you want to take off after execute Combination Stick Commands (CSC), also
you need push the RC throttle stick to above half position. Altitude Stabilized Mode did not have
this limit.
(3) If you do not have any control action with 6 seconds after execute Combination Stick Commands
(CSC),the FY-41AP will into the state before execute Combination Stick Commands. If you want to
take off ,you need to execute Combination Stick Commands again.
1) Altitude Stabilized Mode: If the RC throttle stick is not in the lowest position,FY-41AP will not
into the state before execute Combination Stick Commands.
2) Hovering mode: When your aircraft landed into the ground , And FY-41AP detected there is no
altitude change, it will closed the engine and into the state before execute Combination Stick
Commands.
(4) Auto Return To Launch Mode(RTH) is all controlled by FY-41AP,RC sticks human intervention is
invalid.
(5) Wind pressure in the volatile situation, due to the throttle closed protection restrictions, hovering
mode and Auto Return To Launch Mode(RTH) may appear the situation which can not closed the
throttle, then you just need to put the RC throttle stick to the lowest and switch into Altitude
Stabilized Mode.