FeiYu Tech FY-41AP - Manual (Page 23)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
- 23 -
Attempt to fly
To use the default control parameters, execute Combination Stick Commands (CSC)
in stabilized mode and takeoff. Manually control the aircraft and attempt to hover at the
height of about 1 meter. Get a feel for the attitude stability, and then manually change
the attitude through your RC, and then loosen the RC sticks and observe the aircraft
auto-recovery levels and retention capacity. If improper, then land the aircraft and perform
further debugging.
Install propeller
In order to install the propeller, please follow the motor rotation direction according
to the picture s found in the ―Motor Mixer‖ section on page 20 of this manual.
Check the control direction of RC corresponding channel
After installation is complete, please execute Combination Stick Commands (CSC)
in stabilized mode or in Hovering mode (Can not in Auto Return To Launch
Mode(RTH) ) to start motors. Slowly push the throttle but do not take off. Check the
control surfaces of the joystick remote control and make sure the aircraft direction is
correct.