FeiYu Tech FY-41AP - Manual (Page 27)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
- 27 -
FAIL-SAFE setting
In order to realize auto return to home when your aircraft out of control, requires your
RC and RC receiver both have ―Fail Safe‖ function.
When the Failsafe remote control receiver doesn‘t receive a signal, it outputs a default
setting for the rudder. Most remote control models have a controlled set runway protection
system. Please refer to your remote control‘s manual to see if your remote has this
function.
Auto return to home when your aircraft out of control require you connect the SW1 to
RC receiver CH5 corresponding channel and adjust your RC to make RC receiver CH5
channel output a out of control signal to make SW1 into RTH mode. And adjust your RC to
make RC receiver throttle channel output a out of control signal to make throttle into
hovering position.
If in debugging balanced mode, the following example is that of a Futaba remote
control T10CHG setting runaway protection. Go to the settings menu, then turn off the
power to the aircraft to avoid setting the motor to start without control.
First enter the remote control setup menu to find the set of "F / S"; into the F / S menu,
put the lever into the neutral position, carefully adjust the settings rudder to maintain the
status adjusted, put the throttle lever to the cruise throttle position, and then put the CH5
cut to return mode . Then in all open channel F / S set the program, as successfully shown
below (usually set by using the ―PUSH‖ button)
After setting the aircraft is powered off, check if it has successfully entered the return
mode. Pay attention to safety, to prevent the Failsafe motor rotation, met items cause
damage.