EXFO IQS-1700 High Performance Power Meter for IQS-500/600 - Manual (Page 123)

SCPI Command Reference
High Performance Power Meter 115
Product-Specific Commands—Description
:INITiate[1..n]:AUTO
Description This command starts or stops an acquisition
using the number of points set with the
TRAC:POIN command, and the sampling rate set
with the SENS:FREQ[:CONT] or
SENS:FREQ:NCON commands.
At *RST, all acquisitions are stopped.
Syntax :INITiate[1..n]:AUTO,CONT|
NCONt
Parameter(s)

StartStop:
The program data syntax for is
defined as a element.
The special forms ON and OFF are
accepted on input for increased readability. ON
corresponds to 1 and OFF corresponds to 0.
This parameter changes the state of an
acquisition:
0 or OFF - Stops the acquisition.
1 or ON - Starts the acquisition.

AcqType:
The program data syntax for the second
parameter is defined as a
PROGRAM DATA> element. The allowed
elements for
this parameter are: CONT|NCONt.