Elenco Snap Circuits SnapMicro I Deluxe ® - Manual (Page 15)

14
8. Using the program editor software, type in the following program:
9. Click the Run button to download the program to the hardware. After the download the output LED
should flash on and off every second. Congratulations! You have just programmed a micro-controller
integrated circuit to make an LED blink. Do not remove parts from the grid they will be used in the next
section. You may remove the Programming Cable now. Take note that turning the S1 switch ON and
OFF does not lose the programming. Turn the switch off to save battery power.
You can check your
program by clicking
the Syntax Check
button (ABC with a
check mark on it).
If Syntax is correct
proceed to step 9.