Eagle Tree Pro, Glide, Flight and Boat Seagull Wireless Telemetry and Data Recorder - Manual (Page 4)

Copyright © 2003-2010 Eagle Tree Systems, LLC
Page 4
Basic Installation and Setup Instructions
This section describes the minimal setup and configuration required to use your system. No computer is required for this
section.
Install your Data Acquisition Module (Recorder)
NOTE: The recorder’s label has a handy color coded means of indicating the polarity of the various connectors. The
red dots on the label, which are on only one side of the text corresponding to each input, indicate on which side of the
plug the red wire should go.
Installing the Pitot Tube for Airspeed Measurement
WARNING: If you mount the Pitot Tube in such a way that it might induce drag on your model, you need to
make sure that it won’t cause the model to become unstable during high speeds!