Dream Property DM7000 - Manual (Page 19)

- 19 -
18. Satellite Configuration
Press the DREAM-Button to enter the OSD-Mainmenu.
Go to (6) Setup -> (2) Service Searching -> (1) Satellite Configuration.
Navigate to the upper Dropdownlist and choose
your appropiate Satellite Configuration and press
the OK-Button. Choose your Satellites the Dish is
adjusted to and press the green Option-Button to
save configuration.
This Configuration might differ from yours.
19. Satfind
Press the DREAM-Button to enter the OSD-Main menu.
Go to (6) Setup -> (2) Service Searching -> (2) Satfind.
Choose from the lower Dropdownlists your preferred
satellite and transponder.
Adjust the Dish towards the desired satellite until
you have a high value on the Signal strength AGC
and on the Signal quality SNR indicator. The BER
should always indicate a value of zero if the Satellite
is locked and synced.
SNR: Signal to Noise Ratio
This Indicator shows the Quality of the Signal.
AGC: Automatic Gain Control
This Indicator shows the Strengh of the Signal.
BER: Bit Error Rate
This Indicator shows the Errors Rate of the Signal.