Dream Property DM8000 HD PVR - Manual (Page 21)

-21-
4. Basic operation
4.1 Turning your Dreambox on and off
Use the Power-Button to turn your Dreambox on and off.
To put your Dreambox into Standby-Mode either press the Power-Button on your remote control or directly on
your Dreambox. The current time will be shown in the Dreambox’s OLED-Display.
Holding down the Power-Button on your remote control for three seconds will put your Dreambox into the
Deep-Standby-Mode.
You can also put your Dreambox into Deep-Standby-Mode by using the OSD main menu. Choose the Option
“Standby / Restart” in the OSD main menu and navigate to “Deep Standby” option afterwards. Pressing the
OK-Button will put your Dreambox into the Deep-Standby-Mode. Alternatively you can push down the Power-
Button on your Dreambox for 5 seconds. If no OSD Menu is visible on the screen this will also put your
reambox into Deep-Standby-Mode.
Answer “yes“ by pressing the OK-Button to finally activate the net-
work device.
The activation process will take a short while.
Once the activation process is finished you will see the message
depicted on the left.
You will see this screen once the activation process was success-
ful. Otherwise you will get the chance to try it once again from the
start.