DaySequerra M4FM - Manual (Page 23)

23
M4FM User Manual
Network Tab
1.
2.
Figure 20.
1. Network Settings – Enables and disables DHCP. Enabling DHCP allows the DHCP router to
chose an IP address for the M4FM and auto-populate the subnet and gateway. The tuners
MAC is READ-ONLY and cannot be changed. Disabling DHCP allows the user to manually
enter the IP address, Subnet, and Gateway. Select SAVE to store the settings. The settings
are not set until saved.
2. Private FTP Settings – Enables and disables the use of a private FTP site to store firmware
updates. Enabling this feature will direct the M4FM to the host IP provided by the user when
checking for firmware updates. Select SAVE after entering the Host IP, User name, Password,
and Port #. The settings are not set until saved.
3. Email Notifications – Enables and disables emails sent out when alarm conditions are active.
To enable enter SMTP IP, Port #, User name, Password, Sender email address, and receiver
email address. Select SAVE to save the settings and activate. Settings are not set until saved.
Select TEST to verify that the settings have been entered properly and emails are
sent/received. *Password is case sensitive alphanumeric. No spaces or symbols may be used.
SSL encrypted logins are currently unavailable – coming soon in a future firmware release.
3.