DaySequerra M4FM - Manual (Page 11)

11
M4FM User Manual
click of the ‘Check Firmware’ button on the webserver. (A network Internet connection must be
available to successfully upgrade the firmware.)
• AC Power - Auto-sensing 85-264VAC, 47-63Hz input.
• The Power (Rocker) switch is located on the rear panel of the M4FM; when switched on the unit
model number will be displayed on the LCD.
LCD HomeScreen
4
1
2
3
Figure 3.
1. Tuner Frequency – Selects manual FM tuning with UP and DN controls. Press the center
button once to bring up the selection arrow and navigate to position 1 as described above.
(Note the arrow will timeout after 15 seconds of inactivity). Press the center button again
(flashing arrow) indicating the station is ready to be tuned. Press the center button again to exit
or wait 15 seconds for it to timeout.
2. Station Call Letters – Displays the station call letters with the Band. (Read-only)
3. IP & RDS/RBDS Data – Toggles between a static IP address and decoded RDS/RBDS data for
display on the bottom of the LCD. This field also displays active alarm details, which override IP
and RDS/RBDS data.
4. RF Indicator – Horizontal strength bars are displayed indicating the RF strength. (Read-only)
5. BAND/PRESET – FM Band indicator; 50 FM stations are available to be stored. To store a
station as a preset hold the center button for 3 seconds while tuned to the desired station. The
next available preset will start flashing in place of FM. Example F-01. While flashing the arrow
buttons can navigate to any of the already saved preset to be overwritten.
6. ST/Mono – Indicator displaying a Stereo or Mono signal that M4FM has locked on to. Selecting
Mono while locked on to Mono will force the M4FM to Mono.
7. Modulation - enters a submenu displaying measurements for Audio, Demodulation, and
Subcarriers. More information on Modulation on the next page.
5
6
7