1 > faq & troubleshooting – Austin Hughes X-800 Smartcard Handle User Manual

Page 85

www.austin-hughes.com

UM-X-ISM-Q414V3

P.80

Replacement of InfraBox

1. How to replace a failed InfraBox in a DAISY CHAIN network with a new one?

Step 1

- Confi gure the IP address of the new InfraBox as the failed one

( Please refer to user manual < 2.2 > InfraBox X-1000 / X-2000 for details )

Step 2

- Prepare an appropriate length Cat. 5 / 6 cable

Step 3

- Use a Cat. 5 / 6 cable to bridge over the failed InfraBox which will be replaced to minimize

data loss

Step 4

- Remove all connected handles, sensors, PDUs and fan units from the failed InfraBox

Step 5

- Power off and remove the failed InfraBox from connection

Step 6

- Install the new InfraBox, cancel the cable-bridging and reconnect the InfraBox to the previ-

ous and next one

Step 7

- Power on the new InfraBox

Step 8

- Reconnect the removed handles, sensors, PDUs and fan units to the new InfraBox

Step 9

- Confi gure the new InfraBox in < CA – Edit Mode >

Ignore step 2 and 3 if the InfraBox is in the last position of the daisy chain

2. How to replace a failed InfraBox in a STAR network with a new one?

Step 1 -

Confi gure the IP address of the new InfraBox as the failed one

( Please refer to user manual < 2.2 > InfraBox X-1000 / X-2000 for details )

Step 2 -

Remove all connected handles, sensors, PDUs and fan units from the failed InfraBox

Step 3

- Power off and remove the failed InfraBox from connection

Step 4

- Install the new InfraBox to the connection and power it on

Step 5

- Reconnect the removed handles, sensors, PDUs and fan units to the new InfraBox

Step 6

- Confi gure the new InfraBox in < CA – Edit Mode >

< 14.1 >

FAQ & Troubleshooting

The company reserves the right to modify product specifi cations without prior notice and assumes no responsibility
for any error which may appear in this publication.

All brand names, logo and registered trademarks are properties of their respective owners.