AMT Datasouth M5DT Plus User Manual
Page 30
![background image](/manuals/733867/30/background.png)
28
4.4 Black Mark Sensor Calibration
Set black mark sensor as media sensor and calibrate the black mark sensor.
Please follow the steps as below.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns
green
/
amber
after 5 green blinks.
(Any green/amber
will do during the 5 blinks).
The LED color will be changed as following:
Amber
red (5 blinks)
amber (5 blinks)
green (5 blinks)
green
/
amber
(5
blinks)
red/amber (5 blinks)
solid green
4.5 Gap Sensor Calibration
Set gap sensor as media sensor and calibrate the gap sensor.
Please follow the steps as below.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns
red
/
amber
after 5 green/amber blinks.
(Any
red/amber will do during the 5 blinks).
The LED color will be changed as following:
Amber
red (5 blinks)
amber (5 blinks)
green (5 blinks)
green/amber (5
blinks)
red
/
amber
(5 blinks)
solid green
4.6 PAL application program
PAL programming language allows user to download an auto execution file to flash memory.
The printer will run the PAL application program immediately when turning on printer power.
The PAL application program can be interrupted by the power-on utility.
Please follow the procedures below to skip a PAL application program:
1. Turn off printer power.
2. Press the FEED button and then turn on power.
3. Release the FEED button when LED becomes solid
green
.
The LED color will be changed as following:
Amber
red (5 blinks)
amber (5 blinks)
green (5 blinks)
green/amber (5
blinks)
red/amber (5 blinks)
solid
green
4. Printer will be interrupted to run the PAL application program.