AMT Datasouth M5DT Plus User Manual

Page 26

4.2 Gap/Black Mark Calibration, Self-test, Dump Mode

While calibrate the gap/black mark sensor, printer will measure the label length, print the

internal configuration (self-test) and then enter the dump mode.

Please follow the steps as below.

1.Turn off the power switch.

2. Hold on the button then turn on the power switch.

3. Release the button when LED becomes

amber

and blinking. (Any amber will do during

the 5 blinks).

The LED color will be changed as following order.

Amber

red (5 blinks)

amber

(5 blinks)

green (5 blinks)

green/amber (5

blinks)

red/amber (5 blinks)

solid green

It calibrates the sensor and measures the label length and prints internal settings

then enter the dump mode.

Note:

Please select gap or black mark sensor by Diagnostic Tool or by GAP or BLINE

command prior to calibrate the sensor.

For more information about GAP and BLINE command, please refer to programming

manual.