AMT Datasouth Fastmark 600 - Manual (Page 81)

Fastmark 600 Series User's Guide 81
Appendix A: GENERAL SPECIFICATIONS
Specification Fastmark 602 PAL Fastmark 603 PAL
Print method Direct Thermal or Thermal Transfer
Resolution 203 dpi 300 dpi
Maximum print width 4 inches
Maximum print length 0.4 to 80 inches 0.4 to 54 inches
Maximum print speed 2 to 6 ips 2 to 5 ips
Onboard Memory 2mb DRAM
1mb FLASH ROM
CPU type 32 bit RISC microprocessor
Media Information
Type
Feed Direction
Maximum Width
Minimum Width
Thickness
Maximum Roll size (OD)
Minimum Core size (ID)
Media Sensing method
Roll-Feed, Die-cut Continuous, Fan-fold, tags, ticket, plain
paper, fabric, wristband
Wound-In preferred, will accept Wound-Out
4.3 inches (110 mm)
0.6 inches (15mm)
0.0025 inches to 0.01 inches (0.0635mm to 0.254mm)
6 inches (152mm)
1 inch (25mm), optional adapter for 3 inch ID core
Reflective Sensor
Ribbon Information
Type
Wind Method
Maximum Width
Minimum Width
Maximum Roll size (OD)
Core size (ID)
Core type
Typical ribbon Length
End of Ribbon Method
Wax, Wax/Resin, Resin
Coating Wound-In
4.3 inches (110 mm)
2 inches with Core Adapter
2.67 inches (68mm)
1 inch (25mm)
Two Slots 180 degree apart
Resin 300m, Wax 360m
No motion of Sensor Wheel on Supply ribbon
Label indexing Gap, Black Bar, Continuous
Interface RS-232 Serial (9 pin female), Centronic type Parallel, External
Network Adapter, External USB to Parallel adapter
User Interface 3 buttons (Feed, Pause, Cancel)
3 LED indicators (Ready, Media, Ribbon)
Dimension Height: 8.5 inches
Width: 9.25 inches
Depth: 12.5 inches
Weight: 9.3 lbs
Electrical Auto Voltage Sensing Power Supply
90 to 250 VAC
Operating temperature 40° F to 100° F
10 to 90% humidity non condensing
Windows driver Available for Windows 95/98, XP/2k, NT
Printer emulation PAL, ASCII, Display, HEX