AMT Datasouth Fastmark 600 - Manual (Page 21)

Fastmark 600 Series User's Guide 21
6. Unwrap the Ribbon Supply Roll and prepare to place it into the Supply Holder area of
the print head module. Make sure that the Ribbon is coming off the Top of the Ribbon
Roll and to the front of the printer (Ribbon should be a wound-in type). See Supply
Ribbon Installation figure below.
7. Insert the Ribbon Supply Core into the Ribbon Supply Area by first compressing the
right side spring and snapping the left side of supply core into the left side of the notched
wheel. Make sure that the slots in left side of the core mate with the notches on the left
side ribbon drive wheel.
Figure 12 – Supply Ribbon Installation
Right Side Spring Holder
Ribbon Supply Roll
Ribbon Take-Up Roll