AMT Datasouth Fastmark 600 - Manual (Page 36)

Fastmark 600 Series User's Guide 36
Feature Management Mode
Feature Management Mode (FeatureMan) is a PC based program that directly interfaces with the
printer on the PC’s serial port. All of the printer’s features are easily accessible and can be
configured using the FeatureMan. While in FeatureMan mode the user can use either the mouse
pointer on the PC or the three Keys on the printer to travel through the feature menus.
When this mode is enabled the printer uses the serial interface to communicate feature settings to
the FeatureMan program running on the PC. The printer remains fully functional while in the
Feature Management Mode with the exception that the serial interface is dedicated to the
FeatureMan program and cannot be used for host communication. Refer to the Setup Feature
and Value List for a description of the printer features and their valid range of values.
If the serial interface is used for host communication the printer must be powered off after
configuring the features, reconnected to the host, and powered back on to resume normal printing.
If the parallel interface is used for host communication the printer may be operated directly from
the Feature Management Mode. In this mode of operation the FeatureMan program will
continue to provide front panel control and will display all On line, Off line, PAL programming
and error messages.
Use the following procedure to enable the Feature Management Mode and configure the printer
features.
1. Install the FeatureMan program included on the product CD on to your PC.
2. Attach the printer to the PC using the included serial cable. Be sure to note which COM
port is used on the PC.
3. Run the FeatureMan program on the PC. Select the COM port used as noted in the
previous step. The simulated printer LCD should display “Connecting”.
4. Power on the printer while holding down the FEED key.
5. Release the FEED key after the READY LED flashes once.
6. The printer should now begin communicating with the FeatureMan program. The
printer will run through a series of power up messages ending with an Off line message.
Figure 33 – FeatureMan Program
Displayed messages from printer
Set to match the com port to
which the printer is connected. Press Display Up/Down to
enter setup mode.
Online/Offline button