AMT Datasouth Fastmark 600 - Manual (Page 72)

Fastmark 600 Series User's Guide 72
Printer Detected Errors (Continued)
Error: Image System Error reported by the imaging sub-
system indicating a memory
shortage or other graphics problem. Press the FEED key to remove current print
job. Cycle power on the printer. Verify
communications settings are correct. Re-
send the print job.
Error: Data Format The printer has detected a data
format or parity error on the serial
port. This could be caused by
improper settings between host and
printer or a glitch in data
transmission such as a PC being
powered up. Press the FEED key to clear the error and
print buffer. Re-send the print job. If the
error occurs again verify baud rate, data bits,
and parity settings match host and cable pin
out are correct.
Error: Data Overrun This error is unlikely to occur and
would indicate data is being
transmitted to the printer faster than
it can be processed. If this error does
occur it might indicate a faulty
parallel cable or other
communication problem. Press the FEED key then cycle power on the
printer. If the error occurs again verify all
communication features are set to match host
and quality interface cables correctly pinned
out are used.
Error: Buffer Overflow This error indicates the printers
incoming print buffer (FIFO) has
overflowed. The most common
cause of this error is improper
handshaking between the printer and
host due to improper settings or
improper cable. Press the FEED key and re-send the print
job. If the error occurs again verify all
communication features are set to match host
and quality interface cables correctly pinned
out are used.
Software Locked This error is reported when PAL
TM
Print and Program firmware is
loaded into a printer after another
type of firmware was previously
installed. Since PAL
TM
Print and
Program firmware is Copyrighted, a
special code is needed to enable it.
Call your sales representative for information
on how to correct this error.