AMT Datasouth Fastmark 600 - Manual (Page 38)

Fastmark 600 Series User's Guide 38
Setup Feature and Value List
FEATURE NAME VALUE RANGE DESCRIPTION
Media Type [ Direct Thermal, Thermal Transfer ] Set to Thermal Transfer if ribbon is used.
Media Sensing [Gap, Continuous, Black Bar ] Set to match media sensing method.
Calibrate Media (Form Length / Gap Length)
automatically displayed and are not
adjustable from this feature. Click the Enter button to initiate the media
calibration. The detected media length and
Gap are displayed. Not required when
Media Sensing is set to Continuous
Sensor Threshold [ 0-255]
Automatically set by Calibration mode.
The lower the number the less sensitive the
Sensor is.
Media Length [ 0.25 - 12.00] (Inches) Automatically set by Calibration mode.
Manual change of this values will reflect in
the Calibrate Media feature.
Media Width
[ 0.5 - 4.05] (Inches, 602)
[ 0.5 - 4.25] (Inches, 603)
Set to media width used.
Present Distance [ 0.00 - 1.00 ] (Inches) The Present Distance is the distance the
printer will push the label out of the printer
after printing a label. Typically this feature
is used to adjust to position of the end of a
label to the tear bar or the Peel Location
when the Peel and Present option is
installed. After setting this feature the
printer will feed to the top of the next label.
Backfeed [Enable, Disable]
This feature controls the back feed of
media.
When enabled, the printer will reverse the
label the distance indicated in the Present
Distance feature.
When Disabled, the printer will not reverse
the label and begin printing immediately at
the current label position. Note: This will
result in no new printing on the portion of
the label presented by the Present Distance
feature.
Present Sensor [Enable, Disable] This feature controls the operation of the
optional present sensor. When installed
and enabled, the printer suspends printing
after each label until it is removed by the
operator. This is typically used when the
peel and present option is installed but
could also be used with the tear bar.