AMT Datasouth Fastmark 600 - Manual (Page 35)

Fastmark 600 Series User's Guide 35
Power up key functions
The table below indicates the function performed when a key is pressed and held while the
printer is powered up.
Key Function
FEED The printer generates a configuration label. See Printing the
Configuration Label for details.
PAUSE The printer performs a Calibration test. See Calibration of
Media Sensor for details.
CANCEL Pressing this key bypasses any PAL TM program that is loaded
into the printer and places the printer in its normal mode.
This is done before loading a new PAL TM program into the
printer. If the CANCEL key is not held down then the
current loaded application will begin running.
Special Power Up Key Function
Enter into Feature Management Mode
Pressing and holding the FEED key until the READY LED flashes one time will
establish a communication between the Fastmark 602 PAL printer and a PC.
This communication is only on the SERIAL port of the printer and FeatureMan
must be active on the attached PC. Note: Entering into Feature Management
Mode automatically establishes the communication parameters (baud rate, parity,
etc) and can not be altered. The Printer is also in an OFF LINE state. Pressing
the PAUSE button will cancel Feature Management Mode and place the printer
ON LINE.
Disabling a PAL TM program
Pressing and holding the FEED key until the READY LED flashes two times
will temporarily disable any loaded PAL
TM program.
Cycling the printer’s power will re-enable the PAL TM program.
ON LINE Key Operation
The table below indicates the functions of a key when pressed after the printer is powered
on and in the ready condition.
Key Function
FEED No function.
PAUSE Places the printer Off Line.
CANCEL No function