Bios security setup screen, Figure 4-5 – ADLINK CoreModule 430 User Manual
Page 47

Chapter 4
BIOS Setup
CoreModule 430
Reference Manual
41
BIOS Security Setup Screen
Figure 4-5. BIOS Security Setup Screen
•
Supervisor Password – [Not Installed]
•
User Password – [Not Installed]
•
Change Supervisor Password
a.
Select Change Supervisor Password from the Security Setup menu.
b. Press
c.
Type the password and press
The screen will not display the password as you type.
d. Re-type the password when prompted by the pop-up entry field and press
If the password is not confirmed when you re-type it, an error message will appear. The password is
stored in NVRAM if you have successfully entered the password.
•
Change User Password
a.
Select Change User Password from the Security Setup menu.
b. Press
c.
Type the password and press
The screen will not display the password as you type.
d. Re-type the password when prompted by the pop-up entry field and press
If the password is not confirmed when you re-type it, an error message will appear. The password is
stored in NVRAM if you have successfully entered the password.
•
Boot Sector Virus Protection – [Disabled; Enabled]
BIOS Setup Utility
Security Settings
Select Screen
Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
v02.xx (C) Copyright 1985-20xx, American Megatrends, Inc.
Supervisor Password : Not installed
User Password :
Not installed
Change Supervisor Password
Change User Password
Boot Sector Virus Protection [Disabled]
Main Advanced PCIPnP Boot Security Chipset Exit
CM430_BIOS_SecurityScreen_a