ADLINK CoreModule 430 - Manual (Page 40)

Chapter 4 BIOS Setup
34 Reference Manual CoreModule 430
8. Restore power to the CoreModule 430 and look for the screen prompt shown below.
Press to update BIOS
9. Press the F4 key to enter Setup (early in the boot sequence if Quick Boot is set to [Enabled].)
If Quick Boot is set to [Enabled], you may never see the screen prompt.
10. Use the key to select the screen menus listed in the Opening BIOS screen.
OEM Logo Utility
The CoreModule 430 BIOS supports a graphical logo utility, which can be customized by the user and
displayed when enabled through the BIOS Setup Utility. The graphical image can be a company logo or any
custom image the user wants to display during the boot process. The custom image can be displayed as the
first image displayed on screen during the boot process and remain there, depending on the options selected
in BIOS Setup, while the OS boots.
Logo Image Requirements
The user’s image may be customized with any image editing tool, and the system will automatically convert
the image into an acceptable format to the tools (files and utilities) provided by ADLINK. The
CoreModule 430 OEM Logo utility supports the following image formats:
• Bitmap image
 16-Color, 640x480 pixels
 256-Color, 640x480 pixels
• JPG image
 16-Color, 640x480 pixels
 256-Color, 800x600 pixels
 256-Color, 1024x768 pixels
• PCX image
 256-Color, 640x480 pixels
• A file size no larger than sample image
NOTE The serial console port is not hardware protected. Diagnostic software that
probes hardware addresses may cause a loss or failure of the serial console
functions.