ADLINK CoreModule 430 - Manual (Page 37)

Chapter 3 Hardware
CoreModule 430 Reference Manual 31
Power Interface
The CoreModule 430 requires one +5 volt DC power source. If the +5VDC power drops below ~4.65V, a
low voltage reset is triggered, resetting the system.
The power input header (J7) supplies the following voltages and ground directly to the module:
• 5.0VDC +/- 5% @ 1.35 Amps
Table 3-16 describes the pin signals of the Power interface, which uses a 10-pin, right-angle header with 2
rows, odd/even sequence (1, 2), and 0.100" (2.54mm) pitch.
Note: The shaded table cells denote power or ground.
Table 3-16. Power Interface Pin/Signals (J7)
Pin Signal Descriptions
1 GND Ground
2 +5V +5 Volts
3 Key/GND Key Pin on connector/Grounded on board
4 +12V +12 volts routed to PC/104
5 GND Ground
6 NC Not connected
7 GND Ground
8 +5V +5 Volts
9 GND Ground
10 +5V +5 Volts