ADLINK PCI-8144 - Manual (Page 73)

MotionCreatorPro 63
5.3.6 Four-Axis Operation Menu
In this menu, users can change the settings four selected axis,
including velocity mode motion, preset relative motion.
1. Distance: Set the relative distance for “Relative Mode.”
It is only effective when “Relative Mode” is selected.
2. Motion Parameters: Set the parameters for single axis
motion.
Z Start Velocity: Set the start velocity of motion in units of
PPS. In “Relative Mode”, only the value is effective. For
example, -100.0 is the same as 100.0.
Z Maximum Velocity: Set the maximum velocity of motion
in units of PPS. In “Relative Mode”, only the value is
effective. For example, -5000.0 is the same as 5000.0.