ADLINK PCI-8144 - Manual (Page 69)

MotionCreatorPro 59
5.3.5 Single Axis Operation Menu
In this menu, users can change the settings a selected axis,
including velocity mode motion, preset relative motion.
1. Get Remain Pulse: Display the value of the remaining
pulse. The related function is
_8144_get_remaining_pulse()
2. Set Remain Pulse: Set the value of the remaining pulse.
The related function is
_8144_set_remaining_pulse()
3. Set Factor bit No:Set int_factor bit for normal motion
interrupt. The related function call is
_8144_set_motion_interrupt_factor()
4. Int Occur: Display if the interrupt happened. Show
“Yes” If happened. Otherwise, show “No”.