ADLINK PCI-8144 - Manual (Page 61)

MotionCreatorPro 51
5 MotionCreatorPro
After installing the hardware (Chapters 2 and 3), it is necessary to
correctly configure all cards and double check the system before
running. This chapter gives guidelines for establishing a control
system and manually testing the 8144 cards to verify correct oper-
ation. The MotionCreatorPro software provides a simple yet pow-
erful means to setup, configure, test, and debug a motion control
system that uses 8144 cards.
Note that MotionCreatorPro is only available for Windows 2000/
XP with a screen resolution higher than 1024x768. Recommended
screen resolution is 1024x768. It cannot be executed under the
DOS environment.
5.1 Run MotionCreatorPro
After installing the software drivers for the 8144 in Windows 2000/
XP, the MotionCreatorPro program can be located at path> \PCI-Motion\MotionCreatorPro. To execute the program,
double click on the executable file or use Start>Program
Files>PCI-Motion>MotionCreatorPro.