ADLINK PCI-8144 - Manual (Page 24)

14 Installation
2.6 J1-J8 Pulse Output Type: Differential / Open Col-
lector
Jumpers J1-J8 are used to set the type of pulse output signals.
The output signal type can either be differential line driver or open
collector output. Refer to section 3.1 for detail jumper settings.
2.7 JP2 Direct Control to Stepper
J1 & J2 Axis 0
J3 & J4 Axis 1
J5 & J6 Axis 2
J7 & J8 Axis 3
No. Name Function No. Name Function
1 DGND Bus power ground 2 PB4 Axis 3 Pulser PHB
3 PA4 Axis 4 Pulser PHA 4 PB3 Axis 2 Pulser PHB
5 PA3 Axis 3 Pulser PHA 6 VCC Bus Power +5V
7 DGND Bus power ground 8 PB2 Axis 1 Pulser PHB
9 PA2 Axis 1 Pulser PHA 10 PB1 Axis 0 Pulser PHB
11 PA1 Axis 0 Pulser PHA 12 VCC Bus Power +5V
13 -- N/A 14 -- N/A
15 -- N/A 16 -- N/A
17 -- N/A 18 -- N/A
19 -- N/A 20 -- N/A
Table 2-2: JP2 Direct Control to Stepper