Denon DN-V1700 - Manual (Page 31)

ENGLISH
31
2 Label format
• Label lines may consist of any character strings of up to 8 characters beginning with a sharp (“#”) (maximum 9 characters
including the “#”).
• The sharp is omitted when specified as such parameters as “GOTO”, “ONKEYGO”, or “ONBREAK”.
• The characters that can be used in label names are capital letters “A to Z”, small letters “a to z” and numbers “0 to 9”.
2 Parallel remote terminal
During script playback, parallel remote terminal pins 1 to 6, 11 and 12 function as keys 1 to 8, and can be used with the script
command “ONKEYGO”, for example.
2 List of script commands
(“n” refers to an integer)
Command @
0 1 comment
Format
;
Description
Comment
0 2 play PLAY
Playback of 1 or 2 files. The script does not move to the next step unless the file is
played to the file end
0 3 play standby PLAYRDY Preparation for file playback
0 4 play start PLAYGO Start playback of file for which the play standby mode is set from the specified TC
0 5 end END End/change script file execution
0 6 pause PAUSE Set pause mode (screen blacked out)
0 7 still STILL Set pause mode (still picture displayed on screen)
0 8 stop STOP Stop playback (still picture displayed on screen)
0 9 audio control @ AUDIO Switch audio output on and off
10 video control @ VIDEO Switch video output on and off
11 goto GOTO Forced change of command sequence
12 vitc set @ SETTC Set SMPTE time code
13 wait WAIT Wait specified number of seconds or until specified time code
14 on key goto @ ONKEYGO Set a forced change of command sequence at the time of key input
15 on SMPTE-tc goto @ ONSMPTCGO SMPTE timer interruption
16 if day of week goto @ IFDWKGO Change command sequence according to day of week
17 on rtc goto @ ONRTCGO Real time timer interruption
18 on break goto @ ONBREAK Specify new processing position when an execution break command is received
19 osd display @ OSDDISP Switch user OSD display on and off
20 osd print @ OSDPRT Write 1 line of user OSD
21 osd attribute @ OSDATT Set user OSD attribute
22 osd clear @ OSDCLR Clear line(s) of user OSD
23 tc interrupt control @ TCINT Disable/enable time code interruption
24 rtc interrupt control @ RTCINT Disable/enable RTC interruption
25 com-port set @ COMSET Serial port communications mode setting
26 com-port put @ COMPUT Output 1 line from serial port
27 parallel out set @ OUTPORT Parallel remote output terminal setting
28 drive change DRV Change current drive
29 site command enable @ SITECMD Enable acceptance of site command
30 SNTP time calibration TIMECAL Time calibration by SNTP server
31 still mode set @ STLMODE Set screen display in still mode
32 variable set @ SET Set loop counter value
33 loop LOOP Loop according to loop counter and label
✽ “@” in the “@” column indicates commands for which “@” can be used.
34 write log file WRITELOG Output log to file