Denon DN-V1700 - Manual (Page 21)

ENGLISH
21
With the DN-V1700, the play mode can be set by serial control, in which case the playback operation is as described below.
When a serial control command is executed during playback, repeated play or continuous play is ended.
Sorting order
Single
mode
1
Ascending
OFF
The files in the directory are played in ascending file name order.
✽ Default setting
Repeat
mode
OFF
The files in the directory are played repeatedly in ascending file name order. ON 2
ON
Only one file is played. OFF
One file is played repeatedly. ON
3
4
5
Descending
OFF
The files in the directory are played in descending file name order. OFF
The files in the directory are played repeatedly in descending file name order. ON 6
ON
Only one file is played. OFF
One file is played repeatedly. ON
7
8
2 Stopping playback
To stop playback, press the STOP button.
When playback has been stopped, the file that was playing at that point is set as the current file.
For images, the still mode is set at the point at which the image was stopped.
2 Playing the next file
• In the stop mode
Press the SKIP 9 button, then press the PLAY/PAUSE button.
• In the play mode
Press the SKIP 9 button. The next file is played.
2 To play the current file from the beginning or to play a previous file
• In the stop mode
Press the SKIP 8 button, then press the PLAY/PAUSE button.
• In the play mode
Within 1 second from the beginning of the current file, press the SKIP 8 button. The previous file is played. If the SKIP 8
button is pressed more than 1 second into the current file, the current file is played over from the beginning.
13 INTERNAL HARD DISK DRIVE
2 Introduction
The DN-V1700 is equipped with a 2.5-inch sized hard disk drive.
The specifications of the hard disk drive are shown below.
2.5-inch hard disk drive
Item
Type
9.5 mm Height
Max. 1 A (5 V) Power consumption
44-pin ATA Interface
MS-DOS FAT 32, cluster size of 32 kB.
✽ For partition types, the DN-V1700 is only compatible with the “primary partition”, not with the “extended
partition”.
Format
Conforming to SFF-8201 Installation position
Specification
✽1 The hard disk drive is a rotating device, and as such must be replaced periodically.
(The replacement period depends greatly on usage frequency. In general the drive should be replaced anywhere between every 6
months and every 2 years.)
✽2 The DN-V1700’s surrounding temperature must be between 5 and 35°C for the hard disk drive to operate normally. Be particularly
careful not to place the set near a device that generates much heat, causing the surrounding temperature to rise above 35°C.