Directed Electronics VIPER 5701 - Manual (Page 42)

© 2008 Directed Electronics—all rights reserved
Table of zones
A zone is represented by the number of LED flashes used by the system
to identify a particular type of input. Standard input assignments are
listed in the following table, along with spaces to write in any optional
sensors or switches that have been installed.
Zone Description Dealer installed options
1 Trunk Pin
2 Instant trigger: a heavier
impact detected by the
shock sensor
3 Door switch trigger
4 Instant trigger: For
optional sensors
5 Ignition trigger
6 Hood Pin
Interpreting zone diagnostics
Warn Away responses are not reported by arming or disarming diag-
nostics. If you receive a Bypass notification when arming or a Tamper
Alert notification when disarming, look at the LED.
Active or triggered zones will be indicated by a pattern of blinks by the
LED.
For example: If zone 3 was active or triggered, the LED will blink three
times with a two-second pause. Then it will blink three times again,
and repeat until the ignition is turned on.