Arming the system – Directed Electronics VIPER 5701 User Manual

Page 27

Arming the system

To arm the system, press the button on the remote control .

The siren in the vehicle will “chirp” once and the parking lights will

flash once. If the power door locks have been connected, the doors

will lock. The system will automatically check for errors when it arms.

The 2-way remote will “chirp” once and blink the LOCK indicator to

confirm arming. If no arm confirmation is received, the remote will

give the Out-Of-Range signal.

If errors are found when arming:

If an alarm trigger zone – such as a door, the trunk, the hood, or a

sensor, was active at the time of arming, the system will “bypass”, or

ignore, this trigger zone. This allows the system to continue to protect

your vehicle using the remaining trigger zones.

You are notified of this active zone immediately after arming the sys-

tem. The siren in the vehicle will “chirp” again and the parking lights

will flash again. The Status LED indicator in the vehicle will blink in a

pattern to indicate the active zone number error which was found (See

Table of Zones on page 36). The 2-way remote control will sound a

short “error” tone, and blink the LOCK and Function indicators.

Arming without the chirp (Silent Arm)

Press the button at the bottom of the remote once, and then press

the button. The system will arm without the confirmation chirp. The

parking lights will flash once. The 2-way remote will blink the LOCK

indicator to confirm arming. If no arm confirmation is received, the

2-way remote will give the Out Of Range signal.