Multi-car control capability, Adjusting the onboard shock sensor – Directed Electronics VIPER 5701 User Manual

Page 19

Multi-car control capability

You can operate the Responder LE 2-way remote control system for two

cars, with full command capability for both vehicles.

While holding a command button and transmitting, the Amber LED at

the top of the remote control will blink in groups to indicate which Car

is being controlled.

Car 1: 1 blink
Car 2: 2 blinks

To change the Car to be operated:

Press/hold the button for 3 seconds or until the remote beeps and

the and/or

3
4
5
6

A U

LEDs turn on. This will indicate which car the remote

currently operates.

Car 1: 1 beep and Arm LED on
Car 2: 2 beeps and Arm & Disarm LEDs on

Change Car: While the LEDs are on Press and release the button. The

LEDs will change to indicate the car that can be operated. Once the car

number is selected you can press any command button to operate the

system. The selected car remains selected until the setting is changed.

Adjusting the onboard shock sensor

The new Responder LE system has an onboard shock sensor that is

remote adjustable. Adjusting the onboard sensor can be performed

by an authorized dealer (recommended) or by a programmed remote

transmitter.

Transmitter adjustment:

Disarm the unit and exit Valet Mode if ON. Turn the ignition off and

close all entry points (door, hood, trunk).

Use the following steps to put the control module into sensor

▀
▀