Directed Electronics VIPER 5701 - Manual (Page 17)

© 2008 Directed Electronics—all rights reserved
Remote control programming
The Responder LE 2 way remote control has menus for programming the
remote to the system control module including adjusting the control
module onboard shock sensor, and for configuring the remote control
user features.
To program the remote user features:
Press and hold the button for 12 seconds: (at 3 seconds ignore
the Car number indicator.)
The remote emits one long beep, and the Transmit LED turns on.
This indicates the Main menu.
Press and hold the
1
3
4
5
6
2
A U X
button for 1.5 seconds:
The remote beeps two-times, and the Transmit LED blinks
two-times and stays on. You are now in the Remote Configuration
menu.
The Arm, Disarm, Remote Start & Aux LEDs will turn ON, and/or
blink to indicate the current remote feature configuration. When
the LED is ON, the feature is ON.
To configure the remote control features press and release the
command button. The LED next to the button will turn On then OFF.
The remote beeps to indicate the feature configuration.
Button: Auto-Button Lock.
When Arm LED is OFF, buttons will not lock.
LED ON: The buttons automatically lock 60 seconds after the last
button operation to avoid accidental Command operations. When
locked, if any command button is pressed the remote will emit an error
output.
If button lock is ON, press , and then
1
3
4
5
6
2
A U X
buttons.
1.
2.
3.