Directed Electronics VIPER 5701 User Manual

Page 38

controls on.

To perform Valet take-over:

Before turning off the engine, press and release

within 3 sec-

onds on the transmitter. Then wait a few seconds.

Turn the ignition key to the OFF position (The engine will stay

running).

The engine will run until the pre-programmed time elapses or a

shut-down input is received.

Note: To enable Valet take-over with a manual transmission, open the

door when going into a manual transmission mode. After you exit the

vehicle you can arm the alarm and the car will remain running. If the

vehicle shuts down when arming, then the unit did not enter the valet

take-over mode.