System override – Directed Electronics VIPER 5701 User Manual

Page 32

If you hear

five chirps on disarming, the system was repeatedly

triggered in your absence. Immediately look at the Status LED in the

vehicle and count the number of flashes between pauses. This number

is important, it tells what triggered your alarm.

The door locks (if connected) will unlock, and the parking lights will

flash.

While the alarm is triggering:

Press the

3
4
5
6

A U

button on the remote. The siren will stop sounding

and disarm the alarm system.

High-Security Disarming

If you want the Full Alarm response to stop without unlocking the

doors, press the button. The system will re-arm and the current

alarm response will reset.

System override

To disarm the system without a remote control:

You will need to use your Override Switch located on your systems

control center (see diagram below) to disarm the system. The Override

Switch disarms the system only if you have the vehicle key.

To check proper operation:

Open the door. The alarm will sound.

Immediately insert the key into the ignition and turn it to the RUN or

ON position. (all the indicators in the dash will turn on).

Press the Override Switch once.

Note: The Override Switch feature allows you to select a specific

number of presses needed to disarm the alarm. If the Override

▀