Audio adjustment, Graphic equalize, Volume – Aiwa CX-NMT240 User Manual
Page 9: To change the left/right balance, Press one of rock, pop or classic, To cancel the selected mode, Super t-bass system, To select with the remote control, Using the headphones, Sound adjustment during recording
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SOUND
AUDIO ADJUSTMENT
I
VOLUME
GRAPHIC EQUALIZE
GRAPHIC EQUALIZER
PHONES
GEO
in
o
m
Hi
K
a
Q
z
9
O
m
VOLUME
Turn VOLUME on the main unit, or press VOL on the
remote control.
The volume level is displayed as a number from 0 to MAX (50).
The volume level is automatically set to 20 when the power is
turned off with the volume level set to 21 or more.
To change the left/right balance
Press
MANUAL SELECT
on the remote control. L/R is displayed
for 2 seconds. Press ◄◄
DOWN
or ►►
UP
on the remote control
within these 2 seconds
• The DOLBY PRO LOGIC front speakers level is also changed.
(See page 18)
This unit provides the following three different equalization curves.
ROCK:
Powerful sound emphasizing treble and bass
POP:
More presence in the vocals and midrange
CLASSIC:
Enriched sound with heavy bass and fine treble.
Press one of ROCK, POP or CLASSIC.
The selected equalization mode is displayed.
V T-MSS
ROCK POP CLASSIC
"J
To cancel the selected mode
Press the selected button again. “GEO OFF” is displayed.
SUPER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency
sound.
Press T-BASS on the remote control.
Each time it is pressed, the level changes. Select one of the
three levels, or the off position to suit your preference.
\
T-BASS
. f=iOCK POP CLASSIC
■J
To select with the remote control
Press
GEQ
repeatedly. The GEO mode is displayed cyclically
as follows.
ROCK-
POP-
CLASSIC-
GEQ OFF ■
(cancel)
Low frequency sound may be distorted when the T-BASS system
is used for a disc or tape in which low frequency sound is originally
emphasized. In this case, cancel the T-BASS system.
Using the headphones
Connect headphones to the
PHONES
jack with a standard stereo
plug (
06.3
mm,
’/4
inch).
No sound is output from the speakers while the headphones are
plugged in.
• When the headphones are plugged in, the DOLBY PRO LOGIC
is canceled.
Sound adjustment during recording
The output volume and tone of the speakers or headphones are
freely varied without affecting the recording.
ENGLISH
9