English, Precaution, Installation – Aiwa CX-NMT240 User Manual
Page 2: Owner’s record, Electric power, 3 ac power cord, Warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ENGLISH
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK. DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
PRECAUTION
■ CAUTIONTO REDUCE THE RISK OF
ELECTRIC SHOCK.
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL."
Explnnnlion of GiaphiCcil Symbols;
i
Tho lightning flash with ai'owhead symbol,
within an equ,lateral triangle, is intonded to
alert tho user to the presonco of uninsulated
'■dangerous voltage' within the product's
cnciosurc mat may be ol sufficient magnitude
to con.stitiitn a lisk of eiectnc .shock to persons.
1 ho exclamation point within an er.juilatoral
tiiangle is intended to alert tt’e user to the
presence
of
impetant
operating
and
maintenance (servicing) instructions in the
literature accompanying the appliance.
Read the Operating Instructions carefully and completely before
operating the unit. Be sure to keep the Operating Instructions
for future reference. All warnings and cautions in the Operating
instructions and on the unit should be strictly followed, as well
as the safety suggestions below.
Installation
1 Water and moisture
— Do not use this unit near water, such
as near a bathtub, washbowl, swimming pool, or the like.
2 Heat
— Do not use this unit near sources of heat, including
heating vents, stoves, or other appliances that generate heat.
It also should not be placed in temperatures less than 5°C
(41 °F) or greater than 35°C (95°F).
3 Mounting surface
— Place the unit on a flat, even surface.
4 Ventilation
— The unit should be situated with adequate
space around it so that proper heat ventilation is assured.
Allow 10 cm (4 in.) clearance from the rear and the top of the
unit, and 5 cm (2 in.) from each side.
- Do not place the unit on a bed, rug, or similar surface that
may block the ventilation openings.
- Do not install the unit in a bookcase, cabinet, or airtight rack
where ventilation may be impeded.
5 Objects and liquid entry —
Take care that objects or liquids
do not get inside the unit through the ventilation openings.
6 Carts and stands —
When placed
or mounted on a stand or cart, the
unit should be moved with care.
Quick stops, excessive force, and
uneven surfaces may cause the
unit or cart to overturn or fall.
7
Condensation
— Moisture may form on the CD pickup lens
when:
- The unit is moved from a cold spot to a warm spot
- The heating system has just been turned on
- The unit is used in a very humid room
- The unit is cooled by an air conditioner
When this unit has condensation inside, it may not function
normally. Should this occur, leave the unit for a few hours,
then try to operate again.
8 Wall or ceiling mounting
— The unit should not be mounted
on a wall or ceiling, unless specified in the Operating
Instructions.
Owner’s record
For your convenience, record the model number and serial
number (you will find them on the rear of your set) in the space
provided below. Please refer to them when you contact your Aiwa
dealer in case of difficulty.
Model No.
Serial No. (Lot No.)
CX-NMT240
SX-NA332
SX-R275
SX-C605
TS-W45
Electric Power
1 Power sources
— Connect this unit only to power sources
specified in the Operating Instructions, and as marked on the
unit.
2 Polarization
—As a safety feature, some units are equipped
with polarized AC power plugs which can only be inserted
one way into a power outlet. If it is difficult or impossible to
insert the AC power plug into an outlet, turn the plug over and
try again. If it still does not easily insert into the outlet, please
call a qualified service technician to service or replace the
outlet. To avoid defeating the safety feature of the polarized
plug, do not force it into a power outlet.
3 AC power cord
- When disconnecting the AC power cord, pull it out by the
AC power plug. Do not pull the cord itself.
- Never handle the AC power plug with wet hands, as this
could result in fire or shock.
- Power cords should be firmly secured to avoid being severely
bent, pinched, or walked upon. Pay particular attention to
the cord from the unit to the power outlet.
- Avoid overloading AC power plugs and extension cords
beyond their capacity, as this could result in fire or shock.
2
ENGLISH