Datamax DMX E E-4204 - Manual (Page 63)

E-Class 53
Skips every other label (print quality is good, but every other label is
skipped):
•
The label is formatted too close to the top edge of the label:
Leave white space equal to 8-dot rows (about .02 inch
[.5mm]) at the top of the label.
•
The media is not calibrated: Calibrate it (see Section 4).
•
If equipped, the Adjustable Media Sensor may need to be
repositioned (see Section 3).
•
The media sensor or media sensor circuitry may be
defective: Call for service.
Unable to print in rotation 4:
•
The characters are formatted outside the dimensions of the
label: Check that the row/column values provide enough
room for the height of the image being printed.
Prints light on the right side of the label:
•
The media width adjustment is set for a narrower media
width than is actually being used: Adjust for the media width
(see Section 5).
•
The printhead is not properly aligned: Call for service.
•
The printhead carrier assembly is not latched down: Latch it.
Printer fails to power on:
•
The AC wall outlet may be faulty: Try another outlet.
•
A fuse may be blown: Call for service.
•
The power supply may be faulty: Replace it.
•
A defective power switch may exist on the printer: Call for
service.