Step 14, Right roof panel – Arrow Storage Products CM1014 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
step 14
• Parts Needed For i
Right Roof Panel
i 9984 Right Roof Panel (1)
Installing the roof panels is best done
with a step ladder. Install the first roof
panel at the back right corner of the
building. Each screw and bolt in the
roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square
and level. This will make the roof
panels fit better, and holes will
align. Don't anchor the floor frame.
\
/
9984
STEP
(6) Screws
NOTE
If a Roof Beef-Up Kit was
purchased, assemble prior to
attaching the roof panels.
STEP
1
Locate the roof panels and find the
right roof panel part number 9984.
2
Position the right roof panel at the
back right corner and fasten to the
gable with six bolts and nuts and roof
beams using six screws.
Do not fas
ten the lower end of the panel to the
side wall angle at this time.