A.2 run time errors, Table a-2 error messages of run time errors – Anritsu MP1777A User Manual
Page 115
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A.2 Run Time Errors
The error codes, [-299 and -200], indicate that errors have taken place in the execution controller.
In this case, bit 4 of the event status register is set.
Errors take place when the following events take place.
• When the
• The program message cannot be executed because of the device status.
Table A-2 Error Messages of Run Time Errors
Appendix A SCPI Error Messages
Code
Message
Error Detection Condition
-220
Parameter error
An error was found in the parameter.
-221
Setting conflict
Although the setting is correct as a parameter, it cannot be set because of the
device status.
E x a m p le :
A self-diagnosis was attempted during measurement.
A rate greater than that of the interface was specified as the
final MUX stage.
-222
Data out of range
The numeric data has exceeded the device specifications.
E x a m p le :
SENSe : MEASure : PERiod 0, s
; SYSTem : MEMory : STORe 25
-223
Too much data
The length of the string data has exceeded the specified length.
E x a m p le :
The following setting was used when word data of 16 characters
was specified.
: SENSe : TELecom : PATTem : UWORd "11001100110011001"
-224
Illegal parameter value
Using the parameter received is disabled.
E x a m p le :
1. The character data comes outside the specified range.
: SENSe : TELecom : BRATe M15
2. The string data comes outside the specified range.
: CALCulate : DATA? "LAST ; EC ; CMI"
-240
Hardware error
The command cannot be executed because of hardware failure.
-241
Hardware missing
The command cannot be executed because the option is not mounted.
A-4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888)