SINGER 201K User Manual

Page 58

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

THE ADJUSTABLE HEMMER

To Make Hems
from 3/16 to 15/16 Inch Wide

1. Attach adjustable hemmer to presser

bar in place of presser foot,

2. Pull up bobbin thread as instructed

on page 19.

3. Loosen thumb screw on hemmer and

move scale until pointer registers
with number of desired width of hem.

(No. 1 indicates the narrowest hem

and No. 8, the widest.) Then tighten
thumb screw.

4. Place cloth in hemmer and draw it

back and forth until hem is formed

as shown.

5. Draw end of hem back under needle,

lower presser bar and start to sew.

6. Guide sufficient cloth into hemmer ta>

turn hem properly.