SINGER 201K - Manual (Page 16)

Fig. 12* Winding the Bobbin.
Remove bobbin from spindle and tighten
knurled screw 17.
If pressure of bobbin winder pulley
against bub of hand wheel is insufficient
for winding the bobbin, press down bobbin
winder until latch 15, Fig. 13 drops and
holds it in position. Loosen adjusting
screw 18, Fig. 13. With forefinger, push
back upper end of slotted plate 19 as far
as it will go, as shown in Fig. 13, and at
the same time, press bobbin winder
pulley against hub of hand wheel. Tight­
en adjusting screw 18. If thread does
not wind evenly on bobbin, loosen screw
which holds tension bracket 13, Fig. 12
in position. Move bracket to the left if
bobbin winds high on right; move
bracket to the right if bobbin winds high
on left. When bracket is properly
centred, thread will wind evenly across
bobbin.
Bobbins can be wound while machine is
sewing. Follow instructions on page 13
omitting item 4.
14