SINGER 201K - Manual (Page 22)

TO REMOVE THE WORK
Stop the machine with the thread take-
up lever 5, Fig, 10 at its highest point.
Raise the presser foot by means of presser
bar lifter J, Fig. 19, draw the fabric back
and to the left and sever the threads on
thread cutter F, Fig, 19. Place ends of
threads under presser foot.
CAUTION :
When the machine is not in use, raise
the presser foot by means of presser bar
lifter J to prevent injury to the presser
foot G and the feed H, Fig. 19,
TO REGULATE LENGTH OF
STITCH AND DIRECTION OF
FEED.
See Fig. 20.
The machine can be adjusted to make
from 6 to 30 stitches to the inch, as
indicated by the numerals on the stitch
indicator plate.
Loosen screw A and lower it to the
bottom of the slot, then move lever B
until its top edge is level with the figure
denoting the number of stitches desired
per inch. Raise screw A as far as possible,
and tighten it. Thus set, the machine
will make the indicated number of
stitches in a forward direction. If it is
desired to reverse the direction of the
stitching, raise lever B as far as possible,
and the machine will make the same
number of stitches in a backward
direction.
20