SINGER 201K - Manual (Page 33)

dve the screwdriver one half turn to the
right so that it will drop into the slot and
unlock the spring.
With the right hand hold the hand
wheel to prevent its turning and» with
the left, place the screwdriver against
the edge of the slot in the ring and push
it around in the direction opposite to the
hook rotation until the circular cut-out
B is opposite the spring D. The ring and
bobbin case may then be lifted out.
TO REPLACE BOBBIN CASE
See Fig, 32.
When replacing the parts, first place
the bobbin case into position with
the finger A in the opening in the plate
under the feed dog, as shown. Turn the
bobbin case back and forth slightly to
make sure that it is properly seated, then
place the hook ring E in position with the
cut-out B opposite the spring D. Press
the ring into place and turn it in the
direction of hook rotation until the
spring locks it in position. Then replace
the bobbin.
Free instruction for using the machine is gladly given at any
SINGER SEWING CENTRE
31