SINGER 201K User Manual

Page 29

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Text mode
Original mode

TO OIL MACHINE and STAND

K4S3d

Fig, 27, Front View, Showing

Oiling Points,

The Arm Spool Pin C is screwed for

insertion in the left plugged hole and it
is also provided with a screw driver slot.

If the machine is used continuously, it
should be oiled daily. If moderately

used, an occasional oiling is sufficient.

Apply one drop of oil to each of the

places indicated in Figs. 27, 28, 29, 30 and

31 and carefully clean the machin e to

insure smooth and satisfactory perform

ance. Oil holes are provided in the
machine for bearings which cannot be

directly reached.

Remove face plate A, Fig. 27, by taking

out screw B and slipping plate over screw
D, Fig. 28. After oiling replace face plate.
Draw to the left the slide in the bed of the
machine, as shown in Fig. 27, while the