SINGER 7050 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Bring thread from needle, under presser
foot and wind it one turn in any direction,
around presser foot screw (6) pulling it
into groove as shown.
• Begin running machine at a moderate
speed.
• The window in the slide plate lets you
watch the bobbin winding.
• When desired amount of thread has
been wound, stop machine. DO NOT
ALLOW THREAD TO WIND BEYOND
THE OUTSIDE “FULL” RING (7).
• Remove thread from presser foot screw.
• Push button (8) down with your finger
while closing slide plate.
• Raise needle to its highest position.
• Pull 4" (10cm) of thread under foot
toward back of machine, and cut.
• To begin sewing, position needle in
fabric where desired, lower presser
foot and start machine.